So if I go with example three in this diagram I will get the desired effect of dim to bright? just want to be sure I understand correctly. I know the diagram uses improper symbols and that the Pot should be represented with a zig-zaging line to represent resistance, but this image just made sense.
So I was sitting on my duff, and pondering just how I might be able to squeeze out a little better picture out of my modded AES that I just finished adding a Neobitz encoder to. I was wondering if I could remove the 120ohm resistors I have installed on the RGB lines, and replace them with some...
Recently I've had an issue with one of my NeoCD arcade sticks. When ever you push up :up: the input gets messed up and acts like you input an :upb: up diagonal input. Is there a way to fix this? Or replace the joystick with something better?
Just installed a neobits mod and am getting a super washed out image with distortion. I used the tap points from jamma nation x's tutorial page. What could I have done wrong? I redid all the solder points to make sure there were no cold solders too. I have a 3-6 board.
Hello all, Just picked up a used AES board revision 3-5 and there seems to be an issue with the video. I'm getting horizontal lines that run down the left side of the screen. Not sure what I can do to fix this. Any ideas?
(and no this is not the same AES from some of my prior posts where I...