- Joined
- Jun 1, 2009
- Posts
- 1,379
I've taken a stab at trying to repair some CPS2 boards I got really cheap as an excuse to test out my new eprom burner. The pictures below show the graphical issues I'm experiencing.
What I've done thus far.
-Program roms and GFX roms checksums match against the corresponding Mame set.
- All Roms have been re-seated on the "B" board.
- Other "B" boards work fine against this "A" board.
In the searching I've done and speaking with Bustedstr8 in chat. Seems like this could be a ram error. Is there any way to verify the ram is good or bad? I don't have a logic probe, all I got is a multimeter and I don't think any continuity checks would help. I've taken a look at the solder joints on both the ram chips in location 3A & 4A and they look good to me.
I got no problems buying and replacing the sram if it is indeed the issue, just wanna make sure I can properly pinpoint the issue.
Thanks,
Mr_b
What I've done thus far.
-Program roms and GFX roms checksums match against the corresponding Mame set.
- All Roms have been re-seated on the "B" board.
- Other "B" boards work fine against this "A" board.
In the searching I've done and speaking with Bustedstr8 in chat. Seems like this could be a ram error. Is there any way to verify the ram is good or bad? I don't have a logic probe, all I got is a multimeter and I don't think any continuity checks would help. I've taken a look at the solder joints on both the ram chips in location 3A & 4A and they look good to me.
I got no problems buying and replacing the sram if it is indeed the issue, just wanna make sure I can properly pinpoint the issue.
Thanks,
Mr_b