AES power supply question

[vincewy]

I have an extra English AES, serial #019XXX, that I recently decided to boot up, for some reason, none of the power supplies, including those sold at neostore work, except it's 10V or 11V output, I used the Japanese power supplies, 10V and 11V, respectively, both work, 9V generic power supply would display the images with blurred lines.

Where can I find/purchase extra power supply,

Model NEO-POW3

IN - AC 100V 50/60Hz 19VA
OUT - DC 11V 700mA or DC 10V 1000mA (I tried both)


If given options, which would be better hooked up to power lines in US?

Any info would be appreciated


Vince

 

[buckrogers]

Try this thread:

http://www.neo-geo.com/forums/showthread.php?t=132678

There is a descrpancy between your low serial # and the pow model #. Best open the unit and check the board revision and get a suitable psu. I would avoid connecting the unit until you have determined the board rev and made sure you have the correct psu.

 

[vincewy]

What part of the system board would I have to look at for numbers/signs to have a clue, I can open it and give you the number/letters? This was not mentioned in the linked thread, else I would've replied to that thread. One thing for sure, 5V won't work, I won't plug that in again.