xiao_haozi
Avid Neo-Expert
- Joined
- Jan 22, 2009
- Posts
- 1,977
A few more parts questions: I'm thinking of modding my US Tekken V Hori stick with Sanwa or Seimitsu parts,and wondered where a good place is to find those .110 quick disconnects. I just soldered the wires to the terminals on my Agetec stick, which is all well and good until I need to change something. And what's the optimal wire gauge to use for those?
Also, where would I find short plastic risers and accompanying screws? I want to place a sheet or two of acrylic over the exposed parts on my MV1F for looks and to keep the cat from rubbing his face on it, make a semi-enclosed case. I've seen some CMVS' with a similar design in someone's sig here once; I can't find any pictures right now but that was the definite inspiration.
Both of these you should be able to grab at your local hardware store. The disconnects you MIGHT have to grab at a place like radio shack, but I usually get them at the small mom-n-pop hardware shop near my house. Risers and screws you should absolutely be able to get at your hardware store. Mine has a nice selection of plastic, brass, or steel which is nice to give a variety depending on the project.