neo geo mvs big red color bleed in one corner. Fix?

[Ninjainspandex]

the color red seems to be bleeding just a little bit in the upper left hand corner of my screen, is there a way to fix this?

 

[chimera]

This looks like a convergence issue on your monitor with the red color. I could be wrong but my monitor is doing the exact same thing in that corner but not as bad. It looks like on your monitor you can see it very well under the corner towards the center of the screen as well.

I was looking through the manual of my monitor (25k7191) and it says you could adjust the convergence by moving the magnets behind the yoke. On the manual for a wg-k7000 it shows how to adjust them but I haven't really read much into it and to see how detailed it really is in describing how to adjust the three magnets.

Anyway take a look at the youtube video link below. I think doing adjustments like in the video would help.

http://www.youtube.com/watch?v=eDuKddayX-E

OR I could be completly wrong.. lol

 

[Xian Xi]

Not bleeding, just needs tuning to line back up with the grid.

 

[Ninjainspandex]

I bought these Convergence strips, is this what I need to fix it? my googleing says yes. http://www.ebay.com/itm/Reproductio...ltDomain_0&hash=item2588768597#ht_1034wt_1362

 

[chimera]

I bought these Convergence strips, is this what I need to fix it? my googleing says yes. http://www.ebay.com/itm/Reproductio...ltDomain_0&hash=item2588768597#ht_1034wt_1362

The strips seem like a good cheap solution. I dont see why they would work. Post your results!

 

[Nerdygrrl]

Not bleeding, just needs tuning to line back up with the grid.

+1 just needs some tuning.