Lemony Vengeance
Mitt Romney's Hairdresser,
- Joined
- Jan 30, 2012
- Posts
- 4,204
I just installed a Naomi amp into my Egret 2 and wanted to keep the mono/stereo switch functional so I swapped out the stock 3PDT switch for a 4PDT and wired it up like so:
(I forgot to write it down, but I bridged pins 1 and 3 on the switch rather than run another wire from the L- pin on connector "F" as that and JAMMA L are bridged anyway, but the 'Stereo In' end isn't what I'm worried about)
Because it's running through the amplifier I don't imagine there being any issue with running the mono over both left AND right connections when switched to mono, correct?
(I forgot to write it down, but I bridged pins 1 and 3 on the switch rather than run another wire from the L- pin on connector "F" as that and JAMMA L are bridged anyway, but the 'Stereo In' end isn't what I'm worried about)
Because it's running through the amplifier I don't imagine there being any issue with running the mono over both left AND right connections when switched to mono, correct?